How to Replace the Glass Screen on Your iPhone377

Cracked or shattered iPhone screens are a common problem, but they can be expensive to repair at an Apple Store or other professional repair shop. If you're looking to save money, you can actually replace the glass screen on your iPhone yourself with a little patience and the right tools. Here's a step-by-step guide on how to do it:

What You'll Need

Before you start, you'll need to gather the following materials:*
New iPhone glass screen replacement (compatible with your iPhone model)
Screwdriver set (Phillips #000 and Tri-point Y000)
Spudger or plastic opening tool
Suction cup
Heat gun or hair dryer
Isopropyl alcohol (90% or higher)
Lint-free cloth

Step-by-Step Instructions

1. Power Off Your iPhone

Before you begin, make sure to power off your iPhone completely. This will prevent any accidental damage during the repair process.

2. Remove the Bottom Screws

Using the Phillips #000 screwdriver, remove the two screws at the bottom of the iPhone. These screws are located next to the Lightning port.

3. Heat the Screen

Use a heat gun or hair dryer to heat the edges of the iPhone screen for about 30 seconds. This will loosen the adhesive holding the screen in place.

4. Apply Suction Cup

Place the suction cup on the bottom of the iPhone screen, just above the Home button. Pull up gently on the suction cup to create a small gap between the screen and the frame.

5. Insert Spudger

Insert the spudger or plastic opening tool into the gap created by the suction cup. Slide the spudger around the edges of the screen to separate the adhesive.

6. Remove Screen

Once the adhesive is separated, carefully lift the screen up and away from the frame. Be careful not to touch the LCD or digitizer cables.

7. Disconnect Battery

Use the Phillips #000 screwdriver to disconnect the battery connector. This is located near the bottom of the iPhone, next to the Lightning port.

8. Remove LCD and Digitizer Cables

Use the spudger to disconnect the LCD and digitizer cables. These are located near the top of the iPhone, next to the front-facing camera.

9. Remove Glass Screen

Carefully remove the old glass screen from the frame. Be careful not to damage the LCD or digitizer.

10. Clean Frame

Use the isopropyl alcohol and lint-free cloth to clean the frame of the iPhone. This will remove any residual adhesive or dirt.

11. Apply New Adhesive

Apply a thin layer of new adhesive to the frame of the iPhone. Be sure to avoid getting any adhesive on the LCD or digitizer.

12. Position New Glass Screen

Carefully position the new glass screen on the frame. Make sure to align it correctly.

13. Connect Cables

Connect the LCD and digitizer cables to the new glass screen.

14. Connect Battery

Connect the battery connector to the new glass screen.

15. Test Screen

Turn on your iPhone to test the new screen. Make sure it is functioning properly before reassembling the device.

16. Reassemble iPhone

Reassemble the iPhone by reversing the steps above. Start by replacing the screen, then the screws at the bottom. Be sure to tighten the screws securely.

Tips*
Be patient and take your time. Rushing the process could lead to damage.
Use high-quality replacement parts. Cheap or knock-off parts may not fit properly or function correctly.
If you are unsure about any step, consult a professional repair technician.

2025-01-05

Previous：How to Create a Mobile Spreadsheet

Next：Huawei Phone Speed Up Guide: Step-by-Step Video Tutorial