Huawei P9 Front Screen Replacement Guide162

The Huawei P9 is a high-end smartphone released in 2016. It features a 5.2-inch IPS-NEO LCD display with a resolution of 1080 x 1920 pixels. The device is powered by a HiSilicon Kirin 955 octa-core processor and comes with 3GB of RAM and 32GB of storage. The P9 has a rear-facing 12-megapixel dual-lens camera system and an 8-megapixel front-facing camera.

If you have cracked or damaged the front screen of your Huawei P9, you can follow this guide to replace it. Please note that this is a complex repair and requires some technical skills. If you are not comfortable performing this repair, please contact a professional.

Tools and Materials
Replacement Huawei P9 front screen
Phillips #000 screwdriver
Tri-point Y000 screwdriver
Spudger
Plastic opening tool
Suction cup
Heat gun or hair dryer

Instructions
Power off the Huawei P9 and remove the SIM card tray.
Use a Phillips #000 screwdriver to remove the two screws located at the bottom of the phone.
Use a suction cup to lift up the back cover of the phone. Be careful not to damage the fingerprint sensor cable.
Remove the back cover and locate the battery. Use a spudger to disconnect the battery cable from the motherboard.
Remove the two screws located on the top of the motherboard. These screws hold down the motherboard heat shield.
Use a spudger to pry up the motherboard heat shield.
Locate the two screws located on the bottom of the motherboard. These screws hold down the daughterboard.
Use a Phillips #000 screwdriver to remove the two screws.
Use a spudger to pry up the daughterboard and remove it from the motherboard.
Locate the two screws located on the top of the motherboard. These screws hold down the front-facing camera module.
Use a Phillips #000 screwdriver to remove the two screws.
Use a spudger to pry up the front-facing camera module and remove it from the motherboard.
Locate the connector for the front screen. It is located on the bottom of the motherboard.
Use a spudger to disconnect the front screen cable from the motherboard.
Use a heat gun or hair dryer to heat up the edges of the front screen. This will loosen the adhesive that holds the screen in place.
Use a plastic opening tool to pry up the front screen and remove it from the phone.

To install the new front screen, simply reverse the steps above. Be sure to align the new screen properly before pressing it into place. Once the new screen is in place, power on the phone to test it. If the new screen is working properly, reassemble the phone and you're done!

2025-01-11

Previous：Beginner‘s Guide to Big Data Video Course

Next：AI-Powered Landscape Painting: A Comprehensive Guide