Xiaomi Redmi Note 9 Pro Display Replacement Guide353

Introduction

This guide will show you how to replace the display assembly on your Xiaomi Redmi Note 9 Pro. This is a relatively simple repair, but it does require some patience and care. Before you begin, make sure you have the following tools:* A Phillips #00 screwdriver
* A plastic spudger
* A suction cup
* A heat gun or hair dryer
* Replacement display assembly

Step 1: Power off your phone

Before you begin any repairs, it is important to power off your phone. This will prevent any accidental damage to the phone or its components.

Step 2: Remove the back cover

Use your spudger to pry off the back cover of the phone. The back cover is held in place by clips, so you may need to use some force to remove it.

Step 3: Remove the battery

Once the back cover is removed, you will need to remove the battery. To do this, use your spudger to disconnect the battery connector. Then, use your fingers to lift the battery out of the phone.

Step 4: Remove the SIM card tray

Use your spudger to remove the SIM card tray from the phone. The SIM card tray is located on the left side of the phone.

Step 5: Remove the screws

Use your Phillips #00 screwdriver to remove the two screws that secure the display assembly to the phone.

Step 6: Heat the display assembly

Use your heat gun or hair dryer to heat the display assembly around the edges. This will soften the adhesive that holds the display assembly in place.

Step 7: Pry off the display assembly

Use your suction cup to attach the suction cup to the display assembly. Then, use your spudger to pry the display assembly off of the phone.

Step 8: Disconnect the display assembly

Use your spudger to disconnect the display assembly from the phone. The display assembly is connected to the phone by a ribbon cable.

Step 9: Install the new display assembly

Align the new display assembly with the phone. Then, use your fingers to press the display assembly into place. The display assembly should snap into place.

Step 10: Connect the display assembly

Use your spudger to connect the display assembly to the phone. The display assembly is connected to the phone by a ribbon cable.

Step 11: Install the screws

Use your Phillips #00 screwdriver to install the two screws that secure the display assembly to the phone.

Step 12: Install the SIM card tray

Insert the SIM card tray into the phone. The SIM card tray is located on the left side of the phone.

Step 13: Install the battery

Insert the battery into the phone. Then, use your spudger to connect the battery connector.

Step 14: Install the back cover

Align the back cover with the phone. Then, use your fingers to press the back cover into place. The back cover should snap into place.

Conclusion

You have now successfully replaced the display assembly on your Xiaomi Redmi Note 9 Pro. If you have any questions, please feel free to leave a comment below.

2024-11-11

Previous：Comprehensive C Database Tutorial for Beginners

Next：WeChat Official Account Secondary Development Tutorial: A Comprehensive Guide